Installation
The radiator cover fits directly over your radiator or recessed radiator/convector. An anti-tip/wall mount bracket is supplied with each unit. One half of the bracket will come installed on the back of the radiator cover lid. The second half will need to be installed on the wall as follows:
Wall Bracket
1) Put the radiator cover in place and put a pencil mark on the wall where the lid contacts it. The pencil line should be directly above and the same length as the bracket mounted to the back side of the lid.
2) Remove cover and mount wall bracket 1/4 inch BELOW the pencil mark and positioned directly under the pencil mark so that it will match up with the bracket on the back side of the lid.
3) Lower the cover so that the brackets engage each other. If it doesn't engage, then bend the tab on the wall bracket outward slightly.
Alternatively, if do not wish to screw a bracket to the wall, for instance on a tile wall, then a 3M Dual Lock fastener will be supplied which just sticks to the wall.